beautypg.com

Feature descriptions – Clarion SR5000 User Manual

Page 25

background image

26

Menu #3 - Remote Start Features

Feature Descriptions

The features of the system are described below. Features that have additional settings that can be
selected only when programming with the Pro Security Programmer are indicated by the following
icon:

Menu #1 - Basic Features

1-1 ACTIVE/PASSIVE ARMING: When active arming is selected, the system will only arm when
the remote is used. When set to passive, the system will arm automatically 30 seconds after the last
door is closed. To alert the consumer of passive arming, the siren will chirp 20 seconds after the door
is closed. This provides the consumer with an audible warning prior to the system actually arming.
At the 30 second mark, the system will arm, but the siren will not chirp.

1-2 CHIRPS ON/OFF: This feature controls the chirps that confirm the arming and disarming of
the system.

1-3 IGNITION CONTROLLED DOOR LOCKS ON/OFF: When turned on, the doors
will lock three seconds after the ignition is turned on and unlock when the ignition is
turned off. The Pro Security Programmer will display separate steps for ignition lock and

ignition unlock. They can be programmed on or off independently.

1-4 ACTIVE/PASSIVE LOCKING: If passive arming is selected in Feature 1-1, then the system can
be programmed to either lock the doors when passive arming occurs, or only lock the doors when
the system is armed via the remote. Active locking means the system will not lock the doors when it
passively arms. Passive locking means that the system will lock the doors when it passively arms.

Feature

One Chirp

Two-Chirp

Number

Setting Setting

3-1

Engine checking ON

Engine checking OFF

3-2

Engine checking TACH

Engine checking VOLTAGE

3-3

Run time: 12 minutes

Run time: 24 or 60 minutes

3-4

Parking lights flashing

Parking lights constant

3-5

Crank time 0.6 seconds

0.8, 1.0, 1.2, 1.6, 1.8, 2.0, 4.0

3-6

Voltage check - high

Voltage check - low

3-7

Auxiliary output - factory disarm

Special accessory

3-8

Status output

Factory re-arm output

3-9

Anti-grind ON

Anti-grind OFF