Clarion SR5000 - Manual (Page 30)

31
2. K Keeyy.. Turn the ignition ON. (The heavy-gauge PINK wire of the relay
satellite must be connected.)
3. SSeelleecctt tthhee rreecceeiivveerr C Chhaannnneell.. Press and release the override switch the
number of times necessary to access the desired channel. Once you have
selected a channel, press and HOLD the override switch once more. The
siren will chirp and the LED will blink the number of times corre-
sponding to the channel that has been accessed.
NOTE: If adding a remote, a button must be taught to the unit in the Channel One or Channel
Five position prior to programming other channels.
4. PPrreessss tthhee rreem moottee bbuuttttoonn.. While holding the override switch, press the
button from the remote that you wish to assign to that channel. The unit
will chirp indicating successful programming. It is not possible to teach a
remote button to the system more than once.
5. R Reelleeaassee.. Once the code is learned, the override switch can be released
C Chhaannnneellss ##55--77:: Channels 5 through 7 are used to assign the arm, disarm and panic functions to
separate buttons on the remote control. Teaching a button to Channel 5 erases all information about
that remote from memory. Any auxiliary functions that are desired will have to be reprogrammed.
Similarly, if the remote is set up to use the separate arm, disarm and panic channels and a button
from that remote is entered into Channel 1, the remote will be erased from memory, and the system
will only recognize the button that was entered into Channel 1.
Channel Number Function Wire Color
1 Arm/Disarm/Panic
2 Silent Mode/Remote Valet/Trunk Release RED/WHITE
3 Remote Start
4 Second unlock or other accessories VIOLET/BLACK
5 Arm only
6 Disarm only
7 Panic only
8 Auto-learn Standard Configuration*
9 Auto-learn Single Button Arm/Disarm Configuration*
10 Delete all remotes
* *NOTE: For Auto Learn Configurations, see Remote Configurations section of this guide.