Clarion SR5000 - Manual (Page 19)

20
also be used as a (+) hidden switch input and can be connected to any (+) switch in the vehicle. (See
Feature Descriptions section of this guide.)
Programmer Interface, 3-Pin Port
The BLACK three-pin port is provided for programming of the unit. When using the Pro
Security Programmer, it is possible to configure any and all of the programmable functions. For
more information please refer to the guide packaged with the programmer.
Shock Sensor Harness, 4-Pin Connector
GREEN (-) multiplex input, zone 2
Inputs shorter than 0.8 seconds will trigger the warning response, while inputs longer than 0.8
seconds will trigger full alarm sequence and report Zone Two. If installing an optional dual-stage
sensor, connect to the green wire as shown below. The diagram below eliminates the need for diodes
to isolate the sensors.
Diagram for adding optional dual-stage sensor to GREEN wire (Zone 2):
BLUE (-) multiplex input, zone 2
Inputs shorter than 0.8 seconds will trigger the warning response, while inputs longer than 0.8
seconds will trigger full alarm sequence and will also report Zone Two.
RED and BLACK: RED is (+)12V constant, BLACK is (-) ground
Do not use these for anything besides the plug-in shock sensor.