beautypg.com

8 hold1 (40h) – Casio CTK6000 User Manual

Page 13

background image

Receive

Receipt changes the Expression value.

10.7

General Use Controllers 1 through 8 (10H through 13H, 50H through
53H)

On this Instrument, these messages are used to control DSP operation.

Message Format:

BnH 10H vvH

DSP Parameter7[1]

BnH 11H vvH

DSP Parameter7[2]

BnH 12H vvH

DSP Parameter7[3]

BnH 13H vvH

DSP Parameter7[4]

BnH 50H vvH

DSP Parameter7[5]

BnH 51H vvH

DSP Parameter7[6]

BnH 52H vvH

DSP Parameter7[7]

BnH 53H vvH

DSP Parameter7[8]

n:

MIDI Channel Number

vv:

Value

Send

Sent when the DSP parameter setting is configured.

Receive

Receipt changes the value of DSP Parameter 7 [1 to 8] (7-bit parameter) assigned to the part

specified by the MIDI Channel Number. Any message received that corresponds to the parameter of a
number not being used by the currently selected DSP is ignored. For details about Parameter 7 of each
DSP, see the explanations under “VII DSP Parameter List”.

Received values and parameter setting values

The range of the value of each DSP Parameter 7

array element depends on the selected DSP or array number. Unlike manipulation of a DSP parameter
using a System Exclusive Message, a value received by this control change message is always in the range
of 0 to 127, but the range is changed in accordance with the setting range of the applicable parameter
setting. Because of this, it is impossible for a value to be outside of the range. Conversion to the
parameter setting value from the value received with the message can be represented in general terms
by the expression shown below.

Parameter Setting Value = Parameter Minimum Value + (Parameter Maximum Value

Parameter Minimum Value)

Received Value

127

«

10.8

Hold1 (40H)

Message Format:

BnH 40H vvH

n:

MIDI Channel Number

vv:

Value (Note1)

Note1

:

For information about the relationship between setting values and send/receive values, see the “36.1 Off/On Setting

Value Table” in “VIII Setting Values and Send/Receive Values” of this document.

Send

Sent when a pedal that has a sustain (damper) function is operated.

13