beautypg.com

Viking Pump TSM164: GG-AL 4197 User Manual

Technical service manual, Contents introduction, Model number chart special information

background image

SECTION TSM 164
PAGE

1 Of 10

ISSUE

f

VIKING PUMP, INC.

A Unit of IDEX Corporation

Cedar Falls, IA 50613 USA

TECHNICAL SERVICE MANUAL

CONTENTS

INTRODUCTION

The illustrations used in this manual are for identification

purposes only and cannot be used for ordering parts. Obtain a

parts list from the factory or a Viking® representative. Always

give complete name of part, part number and material with

model number and series number of pump when ordering

repair parts. The unmounted pump or pump unit model

number and serial number are on the nameplate.
In the Viking model number system, basic size letters are

combined with series number (4197) and are used to indicate

either an unmounted pump or mounted pump unit.

fIgURE 1

gg, HJ and HL4197 SERIES

foot Type Unmounted Pump with flanged Ports

Introduction . . . . . . . . . . . . . . . . . . . . . . .

1

Special Information . . . . . . . . . . . . . . . . . . .

1

Safety Information. . . . . . . . . . . . . . . . . . . .

2

Special Mechanical Seals. . . . . . . . . . . . . . . .

3

Maintenance . . . . . . . . . . . . . . . . . . . . . .

3

Disassembly . . . . . . . . . . . . . . . . . . . . . .

3

Assembly . . . . . . . . . . . . . . . . . . . . . . . .

6

Thrust Bearing Adjustment . . . . . . . . . . . . . . .

8

Installation of Carbon Graphite Bushings . . . . . . . .

8

Pressure Relief Valve Instructions . . . . . . . . . . .

9

fIgURE 2

AS, AK and AL4197 SERIES

foot Type Unmounted Pump with flanged Ports

UNMOUNTED PUMP

UNITS

Foot Mounted

Units are designated by the

unmounted pump model numbers
followed by a letter(s) indicating
drive style.

D = Direct Drive

GG4197

HJ4197
HL4197

AS4197
AK4197

AL4197

This manual deals only with Series 4197 Heavy-Duty Pumps.

Refer to Figures 1 through 15 for general configuration and

nomenclature used in this manual. Pump specifications and

recommendations are listed in Catalog Section 164, Series

4197 Heavy Duty Stainless Steel Pumps.

MODEL NUMBER CHART

SPECIAL INfORMATION

DANgER !

Before opening any Viking pump liquid

chamber (pumping chamber, reservoir,

relief valve adjusting cap fitting, etc.)

Be sure:
1. That any pressure in the chamber has

been completely vented through the

suction or discharge lines or other

appropriate openings or connections.

2. That the driving means (motor, turbine,

engine, etc.) has been “locked out”

or made non-operational so that it

cannot be started while work is being

done on pump.

3. That you know what liquid the pump

has been handling and the precautions

necessary to safely handle the liquid.

Obtain a material safety data sheet

(MSDS) for the liquid to be sure these

precautions are understood.

failure to follow above listed

precautionary measures may result in

serious injury or death.

Electronic copies of the most current TSM issue can be found on the Viking Pump website at www.vikingpump.com

HEAVY-DUTY STAINLESS STEEL PUMPS

SERIES 4197

SIZES gg, HJ, HL, AS, AK, AL