Viking Pump TSM430: HL-N 34/434 User Manual
Technical service manual, Contents introduction, Special information
SECTION TSM 430
PAGE
1 OF 9
ISSUE
G
VIKING PUMP, INC.
•
A Unit of IDEX Corporation
•
Cedar Falls, IA 50613 USA
TECHNICAL SERVICE MANUAL
CONTENTS
INTRODUCTION
The illustrations used in this manual are for identification
purposes only and should not be used for ordering parts.
Secure a parts list from the factory or a Viking representative.
Always give complete name of part, part number and material
with the model and serial number of the pump when ordering
repair parts.
Introduction . . . . . . . . . . . . . . . . . . . . . . .
1
Special Information . . . . . . . . . . . . . . . . . . .
1
Safety Information. . . . . . . . . . . . . . . . . . . .
2
Maintenance . . . . . . . . . . . . . . . . . . . . . .
3
Disassembly . . . . . . . . . . . . . . . . . . . . . .
6
Assembly . . . . . . . . . . . . . . . . . . . . . . . .
7
Valve Instructions . . . . . . . . . . . . . . . . . . . .
8
UNMOUNTED PUMP
UNITS
PACKED MECH. SEAL
HL34
HL434
Units are designated by the
unmounted pump model
numbers followed by a
letter indicating drive style.
V = V-belt
KK34
KK434
LQ34
LQ434
Q34
Q434
M34
M434
N34
N434
This manual deals exclusively with series 34 and 434
Jacketed General Purpose Pumps. Refer to Figures 1
through 11 for general configuration and nomenclature used
in this manual.
FIGURE 1
ILLUSTRATION OF SERIES 34
JACKETED PUMP
FIGURE 2
CUTAWAY VIEW OF SERIES 434
JACKETED PUMP
SPECIAL INFORMATION
DANGER !
Before opening any Viking pump liquid
chamber (pumping chamber, reservoir,
relief valve adjusting cap fitting, etc.)
Be sure:
1. That any pressure in the chamber has
been completely vented through the
suction or discharge lines or other
appropriate openings or connections.
2. That the driving means (motor, turbine,
engine, etc.) has been “locked out” or
made non-operational so that it cannot
be started while work is being done
on pump.
3. That you know what liquid the pump
has been handling and the precautions
necessary to safely handle the liquid.
Obtain a material safety data sheet
(MSDS) for the liquid to be sure these
precautions are understood.
Failure to follow above listed
precautionary measures may result in
serious injury or death.
Electronic copies of the most current TSM issue can be found on the Viking Pump website at www.vikingpump.com
NOTE: The Technical Service Manual for the electrically heated pumps
is located in the Universal Seal manuals: TSM 630.1 (H-LL sizes),
TSM 630.2 (LS-QS sizes) and TSM 630.3 (N-RS sizes)
JACKETED ASPHALT PUMPS
SERIES 34 AND 434
SIZES HL, KK, LQ, Q, M, N