Unitec ReachFree ID for C-Start - Manual (Page 21)

R E A C H F R E E I D
Document Number: RFID1001 17
Document Name: Unitec RFID Field Retrofit Installation Guide
LEDs Power Level
No LEDs lit 0
1 Green LED middle LED) 1
1 Yellow LED 2
1 Green LED + 1 Yellow LED 3
1 Red LED 4
1 Green LED + 1 Red LED 5
1 Yellow LED + 1 Red LED 6
1 Green LED + 1 Yellow LED + 1 Red LED 7
The bottom pot on the Portal RFID board (top pot on the Sentinel) controls the threshold (rate of
tag reads per second). If you need to adjust the threshold for the reader, insert a small flat head
screwdriver in pot in the slot facing out toward the door of the unit and turn it to adjust the threshold.
The levels range from 1 to 7, with 7 being the highest. Since the pot and power level numbers are
very small, the top 3 LEDS will also light up in the corresponding sequence listed in the table below:
LEDs Read Rate per Second (x6)
No LEDs lit 0
1 Green LED middle LED) 1
1 Yellow LED 2
1 Green LED + 1 Yellow LED 3
1 Red LED 4
1 Green LED + 1 Red LED 5
1 Yellow LED + 1 Red LED 6
1 Green LED + 1 Yellow LED + 1 Red LED 7