Tweco 9-9515 User Manual
Page 4
December 7, 2006
4
Manual 0-4952 Rev. AA.01
7. Disconnect the hardware fastening the side panel to the control module. Carefully pull the panel away from the
module. Any remaining harnesses connected to the PCB on the inside of the panel will restrict motion. Do not
cause any tension on these wire harnesses.
Hardware Locations
Art # A-07025
8. Carefully disconnect any remaining wire harnesses connected to the PCB. The J8 connector for the ribbon cable
includes levers at each end. Move these levers away from the ribbon cable to release the cable from the connec-
tor.
9. When all harnesses are disconnected, let the side panel and PCB assembly lie on a flat surface.
See also other documents in the category Tweco Hardware:
- Mini MIG Guns 160 Amp (1 page)
- ArcMaster 401MST (84 pages)
- ArcMaster 401S (64 pages)
- Eliminator Spool Gun (36 pages)
- Fabricator 252i (100 pages)
- Lightweight Quick Robotic Torch (23 pages)
- QCT-1 (18 pages)
- QFA600 (18 pages)
- QRC-2000 (26 pages)
- QRM-100 (16 pages)
- QRM-3 Anti-Spatter Sprayer (18 pages)
- QRP-IN TCP Check Tool (14 pages)
- Quick Fixed (27 pages)
- Quick Robotic Torch (40 pages)
- QWT-120 (16 pages)
- QWT-3 Quick Wire Trim Unit (16 pages)
- RDM-2000 (22 pages)
- SprayMaster with Velocity Consumables MIG Gun (12 pages)
- 181i (96 pages)
- 211i (96 pages)
- Fabricator 141i Operating Manual (104 pages)
- Fabricator 141i Quick Start (2 pages)
- Victor Torch Handles,Cutting Attachments (94 pages)
- Single & Two Stage Regulators (68 pages)
- 7-3431 (2 pages)
- 7-3436 (2 pages)
- 7-3437 (2 pages)
- 7-3438 (2 pages)
- 7-3439 (2 pages)
- 7-3440 (2 pages)
- 7-3441 (2 pages)
- 7-3442 (2 pages)
- 7-3443 (3 pages)
- 7-3444 (1 page)
- 7-3445 (4 pages)
- 7-3446 (2 pages)
- 7-3448 (2 pages)
- 7-3449 (3 pages)
- 7-3450 (1 page)
- 7-3480 (2 pages)
- 7-3482 (2 pages)
- 9-1001 (1 page)
- 9-8311 (3 pages)
- 9-9385 (4 pages)
- 9-9417 (12 pages)