Tweco 9-9515 - Manual (Page 10)

December 7, 2006 10 Manual 0-4952 Rev. AA.01
3. Refer to Illustration at the end of these instructions. Carefully reconnect all wire harnesses to the 'J' connectors
on the PCB. Refer to Step 4 for details on the harness connector for receiver J6. Close the levers on the ends of
the J8 receptacle to secure the ribbon cable in place. Check all connections for a secure fit. Some connectors
include a locking feature; align the parts as shown, press them firmly together, then check for a secure fit.
Locking Notch
Receiver
Locking Rib
Harness Connector
Harness Receiver
Align Harness Connector
and Harness Receiver Assembled Connector
and Receiver
Art # A-07348
4. If the cable connector has fewer pins than a board receptacle, it may be necessary to trim an alignment pin off
the cable connector as shown. When joining a connector to a receptacle, align the end of the connector with the
number 1 pin on the receptacle.
Cable Connector
Trim Alignment Tab Off
Art # A-07359
1
9 1
9
Align this end
of connector
with receptacle
pin # 1
Even number of sockets on connector, odd number of pins on board receptacle
1
8 1
8
Odd number of sockets on connector, even number of pins on board receptacle
Pin numbers
appearing
on PC Board
Align this end of connector
with receptacle pin # 1
Pin numbers
appearing
on PC Board
Pin numbers
appearing
on PC Board
Pin numbers
appearing
on PC Board
Align this end
of connector
with receptacle
pin # 1
Align this end of connector
with receptacle pin # 1
1
Align this end of connector
with receptacle pin # 1
Pin numbers
appearing
on PC Board
Art # A-07361
Trimmed Tab