Tweco SP SERIE PowerMaster - Manual (Page 24)

4-2 July 7, 2008
Push Pull Interface KIt
4.02 Install the Push-Pull Interface Board
A. Reconnect all plugs to the new PC-board. Note the designations at the board. Refer to Figure 4-3 and 4-8.
Figure 4-3: Connect the New PC-Board
B. Cut and remove both cable tie wraps as shown in Figure 4-4.
Figure 4-4: Remove Cable Tie Wraps
C. Put the cable with the red and blue leads through the cable gland of the intermediate plate. Refer to Figure 4-5.
Figure 4-5: Red and Blue Cable Through Cable Gland