Teradek Beam - Manual (Page 8)

© 2 0 1 4 . T e r a d e k , L L C P a g e | 6
1.4.2 Front and Rear panel of Beam RX
Front View
Item Component Description
1 Power (LED) This LED shows the power status
2 Video (LED) This LED shows the SDI video output signal status. It will blink when there
is no SDI video signal output, and will light when SDI video signal is
outputting
3 Link (LED) This LED shows the Wi-Fi link status. This LED illuminates when video is
received from the TX
4 Fault (LED) This LED illuminates during boot up, or if an error occurs
5 OLED Display The OLED display contains multiple status and configuration screens. These
can be navigated using the Status (6) and Menu (7) joysticks. The main
status screen (shown) displays the WiFi or Ethernet status at top left, the
device mode, video resolution (if decoding), and decoder ID
6
Status Joystick
Use the status Joystick to cycle between Beam’s status screens. Separate
screens contain information about the WiFi, Ethernet, video resolution,
and firmware version
7 Menu Joystick Use the menu joystick to view and modify Beam’s configuration
8 RS-422 RS-422 interface (See section 3.7 for pin description)
9 LAN RJ-45 Ethernet LAN port