SONIQ PB100 - Manual (Page 21)

21
Cleaning the Disc
A defective or soiled disc inserted into the unit can cause sound to drop out
during playback.
Handle the disc by holding its inner and outer edges.
• Do NOT touch the surface of the unlabeled side of the disc.
• Do NOT stick paper or tape on the surface.
• Do NOT expose the disc to direct sunlight or excessive heat.
• Clean the disc before playback. Wipe the disc from the center outward with a cleaning cloth.
• NEVER use solvents such as benzine or alcohol to clean the disc.
• Do NOT use irregular shaped discs (example: heart shaped, octagonal, etc.). They may cause
malfunctions.
Cleaning the Unit
• Be sure to turn the unit off and disconnect the power source before maintaining the unit.
• Wipe the unit with a dry soft cloth. If the surfaces are extremely dirty, wipe clean with a cloth that
has been dipped in a weak soap-and-water solution and wrung out thoroughly. Then wipe with a
dry cloth.
• Never use alcohol, benzine, thinner, cleaning fluid or other chemicals. Do NOT use compressed
air to remove dust.
Important Note
• Before transporting the unit, remove any disc from the disc compartment.
Screen Saver
To turn on or off the screen saver (screen protection to prevent image burn).
Note: When you leave the unit in stop mode for approximately 5 minutes, the screen saver of the
unit automatically appears if you set the Screen Saver to On mode. To turn off the screen saver,
press the PLAY button.
Software Update
For future Product Software Upgrades.
Use Default Settings
Restores your player to the original factory settings. The unit will exit the default setting menu
automatically and re-load the disc in the disc tray.
Note: It will take 3-5 seconds to reset the player to the factory default.
BD-Data Storage
The available storage space is displayed next to BD-Data Storage.
MAINTENANCE
General Setup
1. In STOP mode, press the SETUP button. Press the
button to select General.
2. Use the button to move the highlight bar to the
right, use the or button to select Screen Saver,
Software Update, Use Default Settings and BD-Data
Storage, press the OK button to select.
3. Use the or button to select your settings, then
press the OK button to confirm.
4. Press the button to go back to the previous menu.
Repeat steps 2 and 3 to adjust other options.
5. To exit the SETUP MENU and return to the normal screen, press the EXIT or SETUP button.