Soleus GPS Cross Country (SG005) - Manual - Manual (Page 6)

GPS Cross Country
3.4) TIMER can also be set in TIMER SET mode
• Press and hold S11 until SG 1 (segment 1) blinks.
• Press S5 to set the hour, minute and second.
• Press S7 to set the Timer alert then press S1/S11 to turn ON or OFF.
Step 4) Acquire Satellite signals:
In order to get the correct time of day and begin using your watch, you have to acquire the
Satellite signals. It may take a few minutes to get the signals.
4.1) Go outside to an open area away from tall buildings and trees. Orient the GPS antenna
towards the sky for best reception. The antenna is located at the 12 o’clock position of
the watch.
4.2) Stand still and do not begin moving while locating the Satellites until the GPS signals are
already received.
4.3) How to Turn ON the GPS: Following are the possible ways to turn on the GPS.
4.3.1) Press S1 while in TIME mode. The Watch will display the GPS / INDOOR
selection screen. Select GPS and press S5. Or press and hold S1 and the watch
will start searching for GPS and go to RUN mode.
4.3.2) Press S7 to enter the exercise modes: RUN, CHRONO, TIMER, ALTI, or
COMPASS mode.
4.3.3) Press and hold S7 for 2 seconds from any mode while GPS is initially OFF.
4.4) How to turn OFF the GPS:
4.4.1) Press and hold S7 for 2 seconds from any mode while GPS is initially ON.