Soleus GPS Cross Country (SG005) - Manual - Manual (Page 11)

GPS Cross Country
6.3) Using TIMER mode:
RUN mode & TIMER mode has the same chronograph counter. When the chronograph is
started or stopped in RUN mode, the same thing happens in TIMER mode.
• The watch has 6 interval timers segment 1 to segment 6.
• The default values for all segments are 00:00:00.
• Please set the TIMERS first before using this mode.
• When you start the Chronograph in other modes like RUN mode, the set Timer
segments will also start counting down.
• When a segment reaches zero, there will be a beep sound. The next segment will auto
start the countdown. The cycle will loop for 50 loops.
• If only 1 segment timer is set and the other segments are set to zero, only that segment
will countdown and loop up to 50 loops.
6.3.1. How to enter TIMER mode
• Press S7 to go to Timer mode.
The watch will prompt you to GPS GO (if Satellite signal already received) or INDOOR
(if no signal received).
• When GPS is not yet received when you enter TIMER mode, the watch will display
“SEARCH GPS”. It will be later replaced with “GPS GO” when GPS signal is already
received.
6.3.2. How to START, STOP, and SAVE in TIMER mode.
• Press S1 to start or re-start or stop.
• Press S11 to take manual LAP. If auto lap function is set, the watch will take lap
automatically based on auto lap setting and there is a beep sound during taking of
auto lap.
• Press and hold S1 or press S11 to save your data.
6.3.3. How to change views in TIMER before and after you press S1 to start.
•Press S5 to change the information displayed in Line 2.