Soleus GPS Cross Country (SG005) - Manual - Manual (Page 2)

GPS Cross Country
Step 2) Charging the Battery:
Charge the unit for at least 4 to 5 hours before first use. The length of time for a fully charged
battery will last depending on the actual usage. It is recommended to regularly re-charge your
battery every 1-2 months even if it is not used to maintain good battery condition.
2.1) Plug your USB cable to your PC
2.2) Align the USB charging clip with the 4 contact pins on the back of the watch.
Note: Please thoroughly dry the charging contacts and surrounding area to ensure proper
electrical contact and prevent corrosion.
When the battery is low, it is time to charge the watch.
2.3) Connect the charging clip securely to the watch. The watch will display CHARGE and the
percentage charge level of the battery. There is also a scrolling line at the middle. IF the
watch will start to communicate with the PC using the PC LINK software, the watch will
display PC LINK.
Note: Please thoroughly dry the charging contacts and surrounding area to ensure proper
electrical contact and prevent corrosion.
When the battery is low, it is time to charge the GPS watch. Once the battery is full, it will
display “100% CHARGE”.
Battery low condition:
You cannot turn ON the GPS when the battery is low. The watch will display LOW BATT. You
need to recharge the battery in order to use the GPS again.
Please make sure the battery have enough battery power before doing your exercise in order
not to lose your data. When the battery is low, you can still save the data.
When the battery level becomes very low, the watch will automatically turn OFF the display
(blank-screen).
Step 3) Configure your Watch:
Before using your watch, please set your Watch.
3.1) While in TIME mode, press S7 to go to SET mode and set the following parameters:
AUTO LAP, TIME, UNITS, USER, NIGHT, Contrast, CHIME, ALARM, TIMER, and VIEW.
Press S1 or S11 to change the blinking parameter to set.
How to set the AUTOLAP:
• Press S5 while AUTO LAP is blinking. Auto lap 1 will start to blink.
• Press S1/S11 to change the setting. Auto lap preset settings are: off, 0.4, 1, 2, 3, 4,
and 5 KM.
• Press S5 to confirm and set ALERT ON or OFF.
• Press S1/S11 to change the setting. There is a beep sound and EL on for 10 sec every
auto lap taking when ALERT is set to ON.
• Press S5 to confirm setting and go back to Auto lap setting screen.