Photogenic Professional Lighting Powerlight Manual (various) - Manual (Page 23)

ADVANCED PL2 SERIES ACCESSORIES
PLDD-1 Digital display for Model 1250 only.
The PLDD-1 is a digital display to enhance the resolution and repeatability of the
Model 1250’s Flash analog slide-pot control. It displays only Flash power, over
the full range of 16 to 500 watt-seconds. Resolution of the PLDD-1 is 0.1 f-stop.
The PLDD-1 should be mounted to the umbrella bracket under the housing of the
Model 1250 PowerLight, on flexible rotating mount, or on an extension cable, for
better viewing.
PLDRC-1 Remote digital display and flash adjustment for models
1250DR and 2500DR.
The PLDRC-1 is a digital display to enhance the visibility of, and to change the
Flash power setting. It displays and controls only Flash power, over the full range
of watt-seconds. Resolution is 0.1 f-stop, using the 1/2 f-stop and 0.1 f-stop UP/
DOWN buttons.
The PLDRC-1 should be mounted to the umbrella bracket under the housing of the
PowerLight, on rotating mount, or on an extension cable, for better viewing and
easier control accessibility.
PLDIR-2 Remote digital display and Infrared receiver for models
1250DR and 2500DR. (must be used with PLIRC-2 controller)
The PLDIR-2 is digital display to enhance the visibility of, and to receive infrared
signals to control all functions of the 1250DR and 2500DR PowerLights. It
displays both Flash power and Modeling lamp power and unit number. It has
a green READY indicator and a BI-color indicator for Flash or Model. Behind a
small window is an infrared receiver. Resolution is 0.1 f-stop.
The PLDIR-2 should be mounted to the umbrella bracket under the housing of
the PowerLight. Press the pins on the goose neck into the holes on the back of
the display panel. Screw the goose neck into the threaded hole of the umbrella
bracket. Plug the telephone connector into the socket at the bottom rear of the
PowerLight. The display panel can be turned and the goose neck can be bent to
improve the viewing angle.
PLIRC-2 Infrared remote controller for models 1250DR and
2500DR (must be used with PLDIR-2 receivers).
Similar to TV, VCR, DTV universal remote controllers, the PLIRC-2 can control up to
nine (9) PowerLights with individual settings. If several PowerLights are used with
identical settings the same unit number can be assigned to them. This will expand
the total number of lights that can be controlled with the PLIRC-2. All panel button
controls are available, plus STANDBY.