Kino Flo Blanket Light 6X6 DMX - Manual (Page 10)

10
Four Mega 4Bank DMX Ballasts are required to operate one
Blanket-Lite fixture. Set the unit to “Individual Lamp” mode and
jumper the ballasts together with DMX cables. (See page 11-14 for
Dmx operating guide).
A total of 20 DMX addresses will be required.
Ballast 1 = addresses 1 - 5
Ballast 2 = addresses 6 - 10
Ballast 3 = addresses 11 - 15
Ballast 4 = addresses 16 - 20
Keep in mind that the 5
th
address of each ballast controls the HO/STD
setting for the 4 lamps. The slider must be full up
to activate the STD setting. Positioning the dim slider under 49%
will switch the lamps to HO operation.
The diagram below illustrates the corresponding lamp addresses to their
position on the Blanket-Lite.
To alternate the lamps turn either 2 center switches 2 & 3 off or 2 outer
switches 1 & 4 off. This will result in an on/off pattern for an even 1 f-Stop
drop in light output.
1
2
4
3
9
8
6
7
11
12
14
13
19
18
16
17
Lamp
Address
Ballast 1
Ballast 2
Ballast 3
Ballast 4