Gossen Mavo-Spot 2 USB User Manual
Page 19
GOSSEN Foto- und Lichtmesstechnik GMBH
19
4.5
Memory Function
In addition to its display memory, the MAVO-SPOT 2 is also equipped with a measured value memory with 1000
memory locations. This function allows you to perform measurements on-site, and to read them out at a later point
in time. Stored values are retained when the instrument is switched off, as well as when the batteries are replaced.
4.5.1
Saving Measured Values (basic function)
Press the
key to select the Mem function.
Perform measurement as described in section 4.2.
The displayed value is saved to memory by pressing the
key. STO (stored) appears briefly at the memory
location display. In addition to the stored value, the number of the memory location is also displayed. Each
additional stored value is saved to the next successive memory location and is assigned the next consecutive
location number. FULL appears at the display when measured value memory is full. It is not possible to save a
single measured value twice.
etc.