E-flite Shoestring 15e ARF - Manual (Page 16)

16 E-flite Shoestring 15e ARF Assembly Manual
 4. Brush a thin layer of epoxy on the bottom of the
fin as shown.
 5. Position the fin back on the fuselage. Use a
paper towel and rubbing alcohol to remove any
excess epoxy.
 6. Use a square to make sure the fin is aligned with
the stabilizer.
 7. Use low-tack tape to keep the fin in alignment
with the stabilizer until the epoxy fully cures.
 8. Use a pin vise and 1/16-inch (1.5mm) drill
bit to drill a hole in the center of each hinge slot.
Drill holes in both the rudder and fin at this time.
This creates a tunnel for the CA to wick into,
making a better bond between the hinge and
surrounding wood.
 9. Place a T-pin in the center of each of the three
hinges. This will center the hinges when installed in
the rudder.