E-flite Shoestring 15e ARF - Manual (Page 13)

13 E-flite Shoestring 15e ARF Assembly Manual
 13. Once the CA has fully cured. Gently pull on the
elevator to make sure the hinges are secure. If any
hinges are loose, reapply CA to the hinge. Flex the
elevator through its range of motion a number of
times to break in the hinges.
Wing and Stabilizer Installation
Required parts
Fuselage assembly Wing panels (right and left)
Clip (2) Stabilizer assembly
Aluminum wing tube
Required Tools and Adhesives
30-minute epoxy Phillips screwdriver: #2
Epoxy brush Ruler
Felt-tipped pen Mixing cups
Mixing sticks Paper towels
T-pin Low-tack tape
Rubbing alcohol Hobby knife with #11 blade
 1. Remove the canopy from the fuselage by sliding it
forward, then lifting it from the fuselage at the rear.
 2. Slide the aluminum wing tube into the socket in
the wing panel. The tube will slide in easily, so do not
force it in any farther than it will easily slide.
 3. Slide the tube into the socket in the fuselage. Make
sure to guide the lead for the aileron servo in the
fuselage when positioning the wing.
 4. Use a clip to secure the wing to the fuselage.
 5. Repeat step 3 to install the second wing panel.