E-flite Shoestring 15e ARF - Manual (Page 10)

10 E-flite Shoestring 15e ARF Assembly Manual
 12. Secure the aileron servo cover using the four
2mm x 12mm sheet metal screws remove in step 1
and a #1 Phillips screwdriver.
 13. Use a pin vise and 5/64-inch (2mm) drill bit to
drill the two holes completely through the aileron for
the aileron control horn mounting screws. The holes
have already been started and are easily found on
the bottom of the aileron
 14. Attach the control horn to the aileron using two
2mm x 12mm sheet metal screws and a control
horn backplate. Use a #1 Phillips screwdriver to
tighten the screws.
 15. With the aileron servo centered, attach the
Z-bend of the 2-inch (52mm) pushrod to the aileron
servo horn. Thread a clevis on the pushrod. Adjust
the clevis so when it is attached to the control horn
the aileron is centered. Tighten the 2mm nut against
the clevis using needle nose pliers to prevent the
clevis from vibrating loose.
 16. Repeat steps 1 through 15 to install the
remaining aileron servo and linkage.