E-flite Piper L-4 Grasshopper 250 ARF - Manual (Page 6)

6 E-flite Piper L-4 Grasshopper ARF Assembly Manual
 3. Use hobby scissors to cut a piece of hook and
loop tape that is the same width as your receiver.
 4. Apply the hook and loop tape to the bottom of
the receiver.
 5. Insert the receiver into the fuselage. It will fit
above the motor box and battery tray as shown
in the photo. Route the Y-harness up through the
fuselage so that it can be accessed later.
 6. Use hobby scissors to cut another piece of hook
and loop tape to the size of your speed control.
Apply the hook and loop tape to the speed control
and place the speed control in the motor box as
shown.
 7. Use hobby scissors to cut a piece of hook and
loop tape the size of the battery. Place the hook
part of the tape on the bottom of the motor box as
shown.
 8. Connect the lead from the speed control to the
adapter plugged into the throttle channel of the
receiver. Tuck the leads neatly inside the fuselage
so it doesn’t interfere with the battery when it is
installed.