E-flite Piper L-4 Grasshopper 250 ARF - Manual (Page 13)

13 E-flite Piper L-4 Grasshopper ARF Assembly Manual
Battery Installation
Required Parts
Fuselage assembly Motor battery
Battery hatch
 1. Position the battery in the battery compartment
as shown. Using the recommended equipment the
battery will be located all the way forward against
the cowling for the correct CG.
 2. Reposition the battery hatch on the bottom of the
fuselage. Magnets will keep the hatch in position
during flight.
Front Windscreen Installation
Required Parts
Fuselage assembly Front windscreen
Windscreen support (2)
Required Tools and Adhesives
Hobby scissors Medium CA
Clear tape
 1. Route the Y-harness to the root ribs of the
fuselage as shown.
 2. Use medium CA to glue the windscreen supports
in position. Make sure to center the supports at the
top as shown.
 3. Fit the front windscreen to the fuselage. If the
windscreen needs trimmed, use hobby scissors to
do so. The outer edges of the windscreen under the
root rib can be cut at this time for a better fit.
 4. Use clear tape in small pieces at the top and
on the sides to hold the windscreen in place. You
can glue the windscreen on if you would like but
it is not suggested just in case you need to do any
maintenance to the airplane at a later date.