E-flite Piper L-4 Grasshopper 250 ARF - Manual (Page 5)

5 E-flite Piper L-4 Grasshopper ARF Assembly Manual
 3. Place one of the servos in the fuselage. You will
notice a slot in the rear servo rail. This is clearance
for the servo wire. The output shaft will face to
the rear of the aircraft. Once the servo is set on
the rails slide it to one side of the fuselage. Do not
secure the servo until instructed to do so.
 4. Insert the second servo in the fuselage. Slide it to
the other side of the fuselage and align both servos
with the predrilled holes in the servo rails.
 5. Use a #0 Phillips screwdriver and the screws
provided with the servos to secure them in the
fuselage.
Receiver and
Speed Control Installation
Required Parts
Fuselage assembly Receiver
Adapter plug
Y-harness
Hook and loop tape Speed control
Servo extension, 3-inch (76mm)
Required Tools and Adhesives
Hobby scissors
 1. Plug the 3-inch (76mm) extension into the
aileron port of the receiver and the Y-harness into
the extension. The adapter will be plugged into the
port for the throttle/speed control. It will also be
easier to bind the receiver to the transmitter now
before installing it in the fuselage.
 2. Plug the rudder and elevator servos into their
respective ports of the receiver.