E-flite Stearman PT-17 15e ARF - Manual (Page 24)

2 244 E-flite Stearman PT-17 15e ARF Assembly Manual
Wing Installation
Parts Required
Fuselage assembly
Wing panels on transport jigs (L & R)
Upper carbon wing tube, 14-3/8-inch (365mm)
Lower carbon wing tube, 10-5/8-inch (270mm)
4-40 x 3/8-inch Allen bolts (4)
#4 washers (12)
Tools Required
3/32-inch balldriver
Ο 1. Install the upper and lower carbon wing tubes in
the wing center section and fuselage.
Ο 2. Slide the left and right wing panel assemblies
approximately half-way on to the wing tubes,
leaving about a 1-1/2-inch gap between the wing
and fuselage/center section.
Ο 3. Connect the aileron servo lead to the extension
lead coming out of the fuselage.
Ο 4. Slide the wing assemblies completely on to the
wing tubes while feeding the aileron servo leads
into the fuselage.
Ο 5. Use a 3/32-inch balldriver to secure the wing
panels with one 4-40 x 3/8-inch Allen bolt and
#4 washer per wing panel.
Ο 6. Remove the rubber bands and transport jigs
before flight.