E-flite T-34 Mentor 25 ePTS RTF manual - Manual (Page 29)

29 E-flite T-34 Mentor ARF Assembly Manual
 2. Once the wing droop has been removed, use a
cleaner to remove the tape residue from the wing.
Note: Check your particular cleaner in an inconspicuous
place before applying it to the wing. If your cleaner is
not compatible with the covering of your aircraft and
damages the covering, it will be in a place that cannot
be seen.
Operational Flap Installation (Optional)
Required Parts
Wing panel (left and right) Flap servo w/hardware
Flap linkage (operational flap)
Required Tools and Adhesives
Phillips screwdriver: #1 Pin drill
Thin CA
Drill bit: 1/16-inch (1.5mm), 5/64-inch (2mm)
 1. Carefully remove the flap stay from the wing panel
as shown.