Positioning the flaps – E-flite T-34 Mentor 25 ePTS RTF manual User Manual

Page 27

E-flite T-34 Mentor ARF Assembly Manual

Positioning the Flaps

Required Parts

Wing assembly

Initial Training Flap Settings



1. Setting the linkage to the third hole back from the

front of the stay sets the flaps to the position for initial

flight training. This will allow the plane to fly at its slowest

speed and will be slowest during landing as well. The

setting for the flaps in this position is 1/2-inch (13mm)

when measured from the trailing edge of the wing to the

trailing edge of the flap.

Intermediate Setting



2. As you continue to advance, the flap linkage can

again be moved forward one hole. The measurement

for the flaps in this setting is 1/4-inch (6mm) from the

trailing edge of the wing to the trailing edge of the flaps.

As described in Step 1, this will allow the aircraft to

fly slightly faster, but will also require a slightly faster

landing speed.