E-flite T-34 Mentor 25 ePTS RTF manual - Manual (Page 22)

22 E-flite T-34 Mentor ARF Assembly Manual
Setting the Control Throws
Required Parts
Assembled airframe Motor battery
Radio system
Required Tools and Adhesives
Ruler
Your transmitter and model come out of the box set up and ready
to fly. Should you need to replace your fuselage or wing due to
a mishap or such, this section will help you reset your control
throws to the factory settings.
Note: Measurements are taken at the widest point on
the surface.
These are general guidelines measured from our own flight tests.
You can experiment with different rates to match your preferred
style of flying.
 1. Turn the radio on and check that the sticks and trims
have been centered.
 2. Plug the motor battery into the speed control.
Set the throttle stick to low throttle and turn on the
speed control.
Important: Always use extreme caution around the
propeller when the motor battery is plugged in. A
spinning propeller can cause serious damage or injury.
It is always best to stay behind the propeller and keep
it away from loose objects when the battery and speed
control are connected.