E-flite T-34 Mentor 25 ePTS RTF manual - Manual (Page 10)

10 E-flite T-34 Mentor ARF Assembly Manual
Tail Installation
Required Parts
Fuselage assembly Stabilizer/elevator
Fin/rudder 3mm washer (2)
3mm locknut (2) 2mm x 8mm sheet metal screw (2)
Tail cone
Required Tools and Adhesives
Phillips screwdriver: #1, #2 Adjustable wrench
Threadlock
 1. Slide the stabilizer/elevator into the slot at the rear of
the fuselage. Make sure the control horn faces the bottom
of the fuselage. Align the holes in the stabilizer with the
holes in the fuselage. Connect the elevator pushrod to the
elevator control horn.
 2. Use a #2 Phillips screwdriver to remove the rudder
control horn. You will need to loosen both the short black
screw and control horn screw to remove the control horn.
 3. Slide the rudder partially into the fuselage. Install the
control horn so the black screw faces the rear of the
fuselage.