E-flite P-38/F-5E Lightning 400 ARF - Manual (Page 9)

E-flite P-38/F-5E Lightning Assembly Manual
Elevator Servo Installation
Required Parts
• Fuselage/center section assembly
• Double-sided tape • Receiver
• Servo w/hardware
• Servo extension, 12 in (305mm)
• Pushrod wire w/clevis, 10 3 /
4
in (273mm)
Required Tools and Adhesives
• Phillips screwdriver (small)
 1. Carefully remove the center section hatch from the
fuselage by lifting it from the rear.
 2. Remove the servo cover from the bottom of the left
boom by lifting it from the rear.
 3. Locate a 10 3 /
4
in (273mm) pushrod wire and remove
the clevis. Slide the wire into the pre-installed tube in the
fuselage threaded end first. The correct tube will exit near
the elevator control horn.