beautypg.com

Aileron servo installation – E-flite P-38/F-5E Lightning 400 ARF User Manual

Page 26

background image

E-flite P-38/F-5E Lightning Assembly Manual

 9. Snap the spinner cone onto the spinner backplate.

10. Repeat Steps 6 through 9 to install the remaining

motor. When checking the second motor in Step 4

(without the propeller installed), the motors will rotate

opposite directions as shown in the photo.

Aileron Servo Installation

Required Parts

• Fuselage/center section assembly

• Double-sided tape

• 3mm x 35mm screw (2)

• Wing panels

• Servo w/hardware (2)

• Servo extension, 9" (228mm) (2)

• Y-harness

• 3mm x 25mm screw (2)

• Pushrod wire w/clevis, 2

1

/

4

in (57mm) (2)

Required Tools and Adhesives

• Phillips screwdriver

 1. Plug the Y-harness for the aileron servos into the

receiver. Connect a 9" (228mm) extension to the harness

and route the extension out where the wing will plug into

the fuselage; run the ends out each side of the wing slots

in the center section.

This manual is related to the following products: