E-flite P-38/F-5E Lightning 400 ARF - Manual (Page 13)

13 E-flite P-38/F-5E Lightning Assembly Manual
Rudder Installation (Optional)
Required Parts
• Fuselage/center section assembly
• CA hinge (6) • Y-harness
• 2mm x 12mm screw (4)
• Servo w/hardware (2)
• Control horn w/backplate (2)
• Servo extension, 12 in (305mm) (2)
• Pushrod wire w/clevis, 10 3 /
4
in (273mm) (2)
Required Tools and Adhesives
• Hobby knife • Felt-tipped pen
• Thin or medium foam-safe CA
Note: The installation of the rudders is optional. If you
choose not to install the rudders, skip to the next section
for the installation of your motor system.
  1. Use a hobby knife with a sharp blade to separate the
rudder from the fin at the molded hinge line.
  2. Use a hobby knife to cut three slots into the rudder
as shown.