E-flite Byp Yak 3D ARF - Manual (Page 5)

5
Important Information About
Motor Selection
We recommend you use the E-flite ™ brushless outrunner
motor Quique Somenzini uses on his Byp Yak. All of our
flight tests were done using the motor listed below with the
Li-Po battery listed below. Another alternative battery is to
use the Thunder Power 730mAh 3-Cell 11.1V Li-Po Battery
(THP7303SJPL) for extended flight time.
Quique Somenzini’s Competition
Outrunner Setup
EFLM1200 Park 370 Brushless Outrunner Motor,
1080Kv
CSEPHX10L 10-Amp Brushless ESC
APC10038SF 10x3.8 Slow Flyer Prop
EFLC3005 Celectra ™ 1–3 Cell Li-Po Charger
Recommended Battery (by E-Flite)
THP4803SJPL 480mAh 3-Cell 11.1V Li-Po, JST
This setup is very light for slow precise indoor flying.
Required Tools and Adhesives
Tools & Equipment
EFLA257 Screwdriver, #0 Phillips (or included with
EFLA250)
EFLA251 Hex Wrench: 3/32" (or included with
EFLA250)
Hobby knife
Square
Ruler
Felt-tipped pen
String
Paper Towels/Tissue
T-Pins
Pliers
Low-Tack tape
Adhesives
EFLA208 Foam CA 1oz/Activator 2oz Pack
EFLA209 Foam Compatible Medium CA, 1oz
Optional Accessories
EFLA110 Power Meter
THP7303SJPL 730mAh 3-Cell 11.1V Li-Po Battery (for
longer flight times)