E-flite Byp Yak 3D ARF - Manual (Page 10)

Wing Installation
Required Parts
• Fuselage • Wing strut (2)
• Lower wing • Upper wing
• Strut reinforcement disk (14)
• .045” x 6" (1.15mm x 153mm) carbon rod (6)
• .045” x 13" (1.15mm x 330mm) carbon rod (2)
• .045” x 12
5 /
8
" (1.15mm x 320mm) carbon rod (2)
Required Tools and Adhesives
• Foam-safe CA • Hobby knife
• Square
 1. Place the fuselage on a flat surface. Use a square
at the rudder to check that the fuse bottom and
fin are square to each other. Lightly sand the
bottom of the fuse where indicated if necessary.
10