E-flite Byp Yak 3D ARF - Manual (Page 18)

Stabilizer and Rudder Installation
Required Parts
• Fuselage • Stabilizer w/left elevator
• Right elevator • Carbon elevator joiner (2)
• Rudder • Control horn (2)
• Hinge tape
Required Tools and Adhesives
• Foam-safe CA • Ruler
• Paper towel/tissue • String
• T-pins • Foam-safe activator
 1. Use foam-safe CA to glue the plywood elevator
horn into position.
Note: Ensure that the holes in the control horn
are in line with the hinge line.
 2. Slide the stabilizer into position, centering it in the
slot. Sight from the rear of the fuselage and check
that the stabilizer is parallel to the wings. If not,
lightly sand the opening in the fuselage.
18