E-flite Byp Yak 3D ARF - Manual (Page 31)

  13. Attach a micro control connector to the horn
on the top aileron. Make sure the hole for the
screw faces towards the wing tip.
  14. Pass the “Z” bend of a 9 1 /
4
" (235mm)
aileron interconnect linkage into the horn on the
bottom aileron. Slide the linkage through the
micro control connector, center the ailerons, and
tighten the 2mm x 3mm screw.
Hint: Lay a ruler from the leading edge to the
trailing edge to check that the upper aileron is
in neutral.
 15. Repeat Steps 13 and 14 for the
remaining aileron.
31