E-flite Byp Yak 3D ARF - Manual (Page 36)

Control Throws
You may set your control throws up for a less sensitive
setup for your first flights. Pilots not used to extremely
maneuverable 3D aircraft, and the use of large amounts
of expo may also chose to program dual rates with
significantly less throw.
Aileron: 2 1 /
2
" (64mm) up 2 1 /
2
" (64mm) down
Elevator: 3" (76mm) up 3" (76mm) down
Rudder: 3" (76mm) left 3" (76mm) right
The throws below are the same as those used by Quique
Somenzini (used with the expo values shown at the right).
Aileron:
3" (76mm) up 3" (76mm) down
Elevator: 4" (102mm) up 4" (102mm) down
Rudder: 4" (102mm) left 4" (102mm) right
Quique Somenzini’s Competition
Radio Setup
These numbers represent the exact radio setup
programmed into Quique’s personal 9303 transmitter
to control his Byp Yak, using only 1 flight mode. Set the
travel settings on all flight control channels (Aileron,
Elevator, and Rudder) to approximately 140–150%.
Make sure you do not overdrive the servos causing
stalling of the servos and excess current draw.
Dual Rates and Exponential Rates
Rudder:
Dual Rate 100% Expo 50%
Aileron: Dual Rate 100% Expo 78%
Elevator: Dual Rate 100% Expo 63%
36