Bosch LOGIXX 9 - Manual (Page 5)

5
Standard accessories
Several accessories are enclosed
with your washing machine. Check
that all the accessories for your
model are enclosed. If specific parts
are missing, contact your dealer
immediately.
Inside the drum:
- Supply hose (blue mark)
- Water drainage hose.
- The bag contains:
- Covers for placing over the
openings when the
transportation bolts have been
removed.
- Lock for drainage hose.
- Wrench for adjustment.
- Elbow for attaching the drain
hose, e.g. into a wash basin
Depending on the connection
situation, the following part is also
required:
- 1 hose clip 24-40 mm
(DIYĂstore) is also required for
connection to a siphon.
Moisture in the drum is due to the
final inspection which every
washing machine undergoes before
it leaves the factory.
On the rear of the appliance:
- Power cord with plug.
C....Connection for supply hose
Useful tools
The following tools are helpful:
- Screwdriver.
- Ring wrench (SW 13) for
removing the transport bolts.
- Spirit level for adjustment.
Dimensions
a = 686 mm
b = 780 mm
c = 940 mm
d = 407 mm
Opening angle 180 °
Weight approx. 100 kg
Installation surface
Stability is important to prevent the
washing machine from wandering"
during the spin cycle.
The installation surface must be
solid and level. Soft floor surfaces,
such as carpets or surfaces with
foam backing, are not suitable.
If the washing machine is to be
installed on a wooden floor:
q If possible, install the washing
machine in a corner.
q Screw a water resistant
wooden board (min. 30 mm
thick) to the floor.
q Secure the front feet of the
washing machine with holding
brackets.
Holding brackets (set) can be
obtained from a specialist store
orĂthe Customer Service
(WMZ 2200).
q The appliance cannot be
topĆmounted.
q The appliance cannot be built
under.
Installation of base
If the washing machine is installed
on a base (order no. WZ 1295),
follow the instructions in the
operating manual!
i Install the holder BEFORE
removing the transportation
protection devices.
Installation in a recess
If the washing machine is to be
installed in a recess, observe the
minimum distances indicated in the
following table:
Distance
Sides 6 mm
Upper edge 305 mm
Rear 64 mm
Front 6 mm