Bosch LOGIXX 9 - Manual (Page 30)

30
Fault Possible cause Remedial action
Foam comes out of the
detergent drawer.
Too much detergent. Add 1 tbs. of fabric softener to ½ litre of water and
pour into dispenser II . g
Reduce the detergent dosage for the next wash
cycle.
Repeat spin cycle. This is not a fault.
Unbalanced load detection system is attempting to
compensate the imbalance by spinning the washing
several times.
Always load large and small items together into the
drum.
The laundry was not
spun.
Large laundry items have become entangled and are
not evenly distributed in the drum. For reasons of
safety the high speed spin cycle was automatically
suppressed.
Always load large and small items together into the
drum.
Programme duration
extended.
This is not a fault.
The foam detection feature has activated an
additional rinsing cycle to reduce the amount of
foam.
Dispensing the correct amount of detergent
This is not a fault.
Unbalanced load detection system is attempting to
compensate the imbalance by spinning the washing
several times.
Always load large and small items together into the
drum.
Poor wash result. Soiling is greater than expected. Select suitable programme.
or
Intensive Wash additional option.
Detergent underdosed. Dose detergent according to the manufacturer's
instructions.
Detergent residue on the
washing.
Some phosphateĆfree detergents contain
waterĆinsoluble residues that may appear as light
spots on the laundry.
Brush out the washing after drying.
Grey residue on the
washing.
Soiling caused by ointment, grease or oil. Select maximum detergent dosage and maximum
permitted temperature for the next wash cycle.
Fault displays
Text on display panel Possible cause Remedial action
Tap closed? Mains water tap is not opened. Turn the tap on. Programme continues. p
Inlet hose kinked or pinched. Eliminate cause.
Filter blocked in water inlet hose. Clean the strainer; see from Page 26.
Water pressure too low. Eliminate cause.
Pump blocked?" Drainage pipe and/or drainage hose blocked. Clean drainage pipe and/or drainage hose.
Door open?" Door not closed properly. Check whether laundry is trapped in door.
Close the door.
If the fault cannot be rectified with the aid of the above table: switch off the appliance, wait 5 seconds, then switch on
the appliance, select and start the programme.
If the fault recurs, call Customer Service, see Page 32.