Bosch LOGIXX 9 - Manual (Page 29)

29
Fault Possible cause Remedial action
Programme does not start.
Start/Pause indicator light
flashes.
Start/Pause button not pressed. Press the Start/Pause button.
Programme does not start. Door not closed properly. Check whether laundry is trapped in door. g
Door open?" indicated in
the display field.
p p y
Close the loading door (a click should be heard).
Programme continues.
Press start" is indicated in
the display field.
End time selected but still not activated by pressing the
Start/Pause button.
Press the Start/Pause button.
Programme does not start.
Time delay" is indicated in
the display field.
End time selected and activated. None. Appliance starts automatically.
Time cannot be set. Programme has already started; when the programme
has started, the time cannot be set.
Wait until programme ends.
Set clock:" text remains in
the display field even
though the Menu button
has been pressed.
The setting has switched from hours to minutes;
bothĂselection points have the same text.
See Set clock", Page 23.
Time is not displayed. Time not set. Set clock; see Page .
End time cannot be Time not set. Set clock; see Page 23.
selected.
Programme has already started; when the programme
has started, the time cannot be set.
Before starting the programme, select and start the
desired end time, see Page 19.
Spin speed cannot be
selected.
Spin cycle is already running; the speed cannot be
changed during the spin cycle.
Select speed before spinning.
se eced
Programme selector is set to Drain; spinning is not
possible with this programme.
If required, select another programme.
Childproof lock cannot be
selected.
The programme has already started. Childproof lock can be selected in pause mode.
Detergent residue in the Damp or lumpy detergent. Clean and dry the detergent dispenser; see Page 26. g
detergent dispensers.
p py g
Use the cap to measure the liquid detergent.
Water does enter the
machine or detergent is not
Mains water tap is not opened. Turn the tap on.
Programme continues. ace o de e ge s o
washed away.
Water tap closed?"
Inlet hose kinked or pinched. Eliminate cause.
Water tap closed?"
indicated in the display
Strainers in supply hose clogged. Clean the strainers; see Page 26.
indicated in the display
field. Water pressure too low. Eliminate cause.
Water not visible in the
drum.
Not a fault.
The water lies below the visible part of the drum.
Washing solution is not
completely drained.
Pump blocked?"
indicated in the display
field.
Drainage pipe and/or drainage hose blocked. Clean drainage pipe and/or drainage hose.
Water runs out from Screw fitting of the inlet hose is leaking. Tighten the screwĆfitting.
under the appliance. Drainage hose is leaking. Replace the drain hose.