beautypg.com

3200 timer setting procedure, Page 5 – Watts Fleck 2750 Brass Valve User Manual

Page 5

background image

3200 Timer Setting Procedure

Page 5

How To Set Days On Which Water Conditioner Is To

Regenerate:
Rotate the skipper wheel until the number “1” is at the red

pointer. Set the days that regeneration is to occur by slid-

ing tabs on the skipper wheel outward to expose trip fin-

gers. Each tab is one day. Finger at red pointer is tonight.

Moving clockwise from the red pointer, extend or retract

fingers to obtain the desired regeneration schedule.
How To Set The Time Of Day:
1. Press and hold the red button in to disengage the

drive gear.

2. Turn the large gear until the actual time of day is at

the time of day pointer.

3. Release the red button to again engage the drive

gear.

How To Manually Regenerate Your Water

Conditioner At Any Time:
1. Turn the manual regeneration knob clockwise.

2. This slight movement of the manual regeneration

knob engages the program wheel and starts the

regeneration program.

3. The black center knob will make one revolution in

the following approximately three hours and stop in

the position shown in the drawing.

4. Even though it takes three hours for this center knob

to complete one revolution, the regeneration cycle of

your unit might be set only one half of this time.

5. In any event, conditioned water may be drawn after

rinse water stops flowing from the water

conditioner drain line.

How to Adjust Regeneration Time:
1. Disconnect the power source.

2. Locate the three screws behind the manual

regeneration knob by pushing the red button in and

rotating the 24 hour dial until each screw appears in

the cut out portion of the manual regeneration knob.

3. Loosen each screw slightly to release the pressure

on the time plate from the 24 hour gear.

4. Locate the regeneration time pointer on the inside

of the 24 hour dial in the cut out.

5. Turn the time plate so the desired regeneration time

aligns next to the raised arrow.

6. Push the red button in and rotate the 24 hour dial.

Tighten each of the three screws.

7. Push the red button and locate the pointer one more

time to ensure the desired regeneration time

is correct.

8. Reset the time of day and restore power to the unit.

This manual is related to the following products: