Watts PWRO5MAN - Manual (Page 5)

5
Adapt-A-Valve™ Installation
Verify contents prior to installation:
( 1 ) - Plastic Adapt-a-Valve™ & Black Collet
( 1 ) - Brass Adapter no washer
( 1 ) - Brass Adapter with black washer
( 1 ) - White rubber washer
Water supply line to the system must be from the cold water
supply line only. Hot water will severely damage your system.
WARNING: Do not use Teflon tape with the Adapt-A-Valve™.
For 3 ⁄
8
" Configuration
For 1 ⁄
2
" Configuration
Step A - Turn off the cold water supply to the faucet by turning the
angle stop valve completely off .
Step B - Open cold water sink faucet to relieve pressure .
Step C - Choosing the configuration that fits your plumbing, at-
tach the Adapt-A-Valve™ as illustrated in the four photos
above .
STEP 2
Watts Chrome Top Mount
Faucet Installation
Gather and identify the faucet pieces.
Step A - Remove faucet base and faucet spout from their respective
plastic bags . From above the sink, feed the faucet tubing
and toggle bolt down through the 1¼" mounting hole in
the sink . Ensure that the soft rubber gasket is uniformly
positioned in between the base of the faucet and the top of
the sink .
Step B - Align the faucet base so that the handle is on the right side
and the base is sitting flush on the sink top . Turn the handle
down (towards you) to the “ON” position to reveal the
tightening screw (located where the spout will be inserted) .
Using a phillips head screwdriver, turn the screw clockwise
until the toggle bolt secures the faucet base snug onto the
sink top .
Step C - Once the faucet base is securely fastened to the sink top,
insert the faucet spout into the faucet base until it is fully
seated . Turn the handle up (away from you) to the “OFF”
position .
Step D - Locate 3 ⁄
8
" blue tubing in parts bag, connect open end of
the 3 ⁄
8
" tubing to the quick-connect fitting located on the
faucet shank .
MiNiMUM MaxiMUM
Mounting Hole Size 1" 1 1 ⁄
4
"
Torque on Toggle Bolt 5 lb.in. (max)
STEP 3
Hot
Supply
Cold
Supply
Hot
Supply
Cold
Supply
(With Brass Fittings)
* Insert White Washer
(Without Brass Fittings)
1 ⁄
2
" Configuration