Hinkley Lighting BARRINGTON 1752 - Manual

assembly instructions
Item No. 1752
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first making all
necessary electrical connections, hanging the fixture from the ceiling, and then
installing the glass.
start here
1752
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
1. Please refer to the hanging instruction sheet (I.S. 19) provided to continue installation
of this fixture. Then refer back to this sheet to install glass.
Drawing 1 - Fixture Assembly
1.1.12
5
4
2
1
3
6
1. To complete assembly of fixture, first slip candle sleeves (1) over socket (2), followed
by candle chaser (3).
2. Fixture can be lamped accordingly at this time.
3. Thread bottom stem (6) into coupler (6a) located at bottom of cluster assembly.
4. Slip glass (4) into bottom roof (5).
5. Slip glass (4) and bottom roof (5) over bottom stem (6), and thread on hex nut (7)
6. Thread hex nut (7) onto end of bottom stem (4) and hand tighten only, to secure glass
and roof to fixture.
7. Slip bottom knob (8) over bottom stem (6) and thread on finial (9) and tighten to
complete assembly.
8
5
9
7
1. To assembly fixture body slip threaded tube (A) along wire and thread into coupler
(B) approximately 3/8”.
2. Thread hex nut (C) along threaded tube and tighten against coupler (B) to lock
thread tube (A) in place.
3. Slip knob (D) along wire and over threaded tube (A).
4. Slip loop (E) along wire and thread onto end of thread tube (A) and tighten to
complete fixture body assembly.
5. Fixture can now be installed, return to instruction sheet for glass installation
procedure.
C
A
D
B
E
6a
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com