Hinkley Lighting BARCELONA FR44106FRM User Manual
Barcelona
FR44106FRM
BARCELONA
ASSEMBLY INSTRUCTIONS
Assembly of this fixture will be accomplished by first installing the mounting hardware
to the junction box, making all necessary electrical connections,mounting backplate to
the wall, attaching the glass and then hanging the crystals.
SAFETY WARNING:
Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
STEP 1
1
Prepare mounting strap (a) by threading nipple into the center hole of
the mounting strap (a), approximately 1/4“- see Drawing 2.
2
Attach mounting strap (a) to junction box (j) using two screws (b) provided.
STEP 2
Make electrical connections from supply wire to fixture lead wires.
Refer to instruction sheet (FRI.S. 18) and follow all instructions to make all necessary
wiring connections. Then refer back to this sheet to continue installation of this fixture.
STEP 3
1
To mount backplate to wall, slip center hole of backplate (e) over nipple (c) and
hold fixture in position - see Drawing 2.
2
Thread decorative knob (d) onto end of nipple (c) and tighten to secure fixture.
3
Fixture can now be lamped accordingly.
STEP 4
1
To install glass, remove screw (1) located in the middle of backplate cradle (4)
- See Drawing 1.
2
Take alabaster shade (2) and slip crossbar (3) into cradle (4) and center.
3
Tighten screw (1) to secure glass to fixture.
STEP 5
Refer to Crystal Installation Sheet provided to install crystals.
[DRAWING 1]
[DRAWING 2]
Bulbs:
60W MED.
9.12.08
800.421.3517 WWW.FREDRICKRAMOND.COM
d
1
a
j
e
c
b
3
2
4