Hinkley Lighting ZELDA 3443PN - Manual

assembly instructions
item No. 3443
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
*** The construction of this fixture will be accomplished by first assembling the
main body of the fixture, installing the mounting bracket, making all necessary
wiring connections, mounting the fiture to the ceiling, and then installing the shade.
start here
3443
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 1 - Fixture Assembly
06.01.13
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, Ohio 44012 800-446-5539 www.hinkleylighting.com
1
2
7
5
3
4
6
8
9
10
13
1. To assemble main body of fixture, first thread hex nut (4) onto end of center stem
(3) apporximately 3/8”.
2. Slip cap (2) onto end of center stem (3) and over the hex nut (4) added previously.
3. Thread the 3/8” of exposed thread of center stem (3) above cap (2) into coupler
(1) located in the center of the socket assembly.
4.Thighten hex nut (4) against cap (2) to secure center stem (3).
5. Slip tube (5) over center stem (3) followed by cap (6).
6. Slip steel washer (7) followed by rubber washer (8) onto end of center stem (3).
Fricition of rubber washer will hold parts in place. Fixture is ready for installation.
Please refer to the hanging instruction sheet (I.S. 19-92) provided to hang this fixture.
Then refer back to this sheet to install the glass.
shade
tab
11
12
1. After fixture body is installed, slip glass (9) onto center stem (3) and hold in
position.
2. Slip rubber washer (10) and thread on ring nut (11) onto center stem (3) to secure
glass.
3. Thread thread decorative ball (12) onto center stem (3) and tighten.
4. Slip shade (13) over glass and set tabs inside shade onto top of glass. Center shade
on glass.