Hinkley Lighting LANZA 3162OZ - Manual

H I N K L E Y L I G H T I N G 33000Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 44.653.5500 hinkleylighting.com
assembly instructions
Item No. 3162
1. Find a clear area in which you can work.
2. Unpack fixture and shade from carton.
3. Carefully review instructions prior to assembly.
1. Prepare mounting strap (A) by threading nipple into the center hole of the
mounting strap (A), approximately 1/4“.- see Drawing 1.
2. Attach mounting strap (A) to junction box (J) using two screws (C) provided.
1. To mount fixture, slip center hole of backplate (E) over nipple (C) and hold fixture in
position - see Drawing 1.
2. Thread decorative knob (D) onto end of nipple (C) and tighten to secure fixture.
*** The construction of this fixture will be accomplished by first attaching the
mounting strap to the junction box, making all necessary electrical connections,
mounting the fixture to the wall, and then installing the shade.
start here
3162
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 1 - Fixture Mounting
Drawing 2 - Glass Installation
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
5
A J
B
C D
E
01.01.13
1. To install shade (1) line up holes in shade bracket (S) with holes (2) in backplate
(E) - see Drawing 2.
2. Slip ball knob screws (3) through holes (H) in bracket and thread into holes (2) in
backplate (E).
H
E
S
1
2
3