Hinkley Lighting NANTUCKET 2376 - Manual

- 1 -
____ Assembly Instructions ____
Item No. 2376
start here ---
1. Find a clear area in which you can work.
2. Unpack Fixture and glass from carton.
3. Carefully Review Instructions Prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the
main body of the fixture, installing the glass, attaching the mounting strap to
the junction box, making all necessary electrical connections, and mounting
fixture to wall.
SAFETY WARNING: READ WIRING AND GROUNDING
INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS.
TURN POWER SUPPLY OFF DURING INSTALLATION. IF NEW
WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR
LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. To install glass, slide glass panel (G) into the glass holder (A) in the door (C). - see
Drawing 1.
2. To install glass into fixture sides place the glass between the glass clips (B) and fold
back the clips over the glass to hold it in place.
Drawing 1 – Fixture Assembly
1. To mount fixture, slip center hole of back plate (E) over threaded tube (C)
and hold fixture in position - see Drawing 2.
2. Thread decorative nut (F) onto end of threaded tube (C) and tighten to
secure fixture.
3. Slip reflector (G) onto threaded tube (C).
4. To complete assembly thread barrel knob (H) onto end of threaded tube (C)
and tighten.
Drawing 2 – Fixture Mounting
Make electrical connections from supply wire to fixture lead wires. Refer to
instruction sheet (I.S. 18) and follow all instructions to make all necessary
wiring connections. Then refer back to this sheet to continue installation of this
fixture.
1. To assemble the fixture top first Thread the nipple (4) into the hex coupling (5). -
see Drawing 1.
2. Align the decorative cylinder (3) over the hex coupling. (5).
3. Slip the decorative cap (2) on top of the decorative cylinder (3) and over the
nipple (4) thread the decorative ball (1) onto the nipple (4).
4. Fixture can be installed at this time.