Hinkley Lighting SORRENTO 1422AI - Manual

assembly instructions
Family: Sorrento Item No. 1422 AI
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the
interior glass globe, installing glass in the cage assembly, attaching the mount-
ing hardware to the junction box, making all necessary electrical connections
and then mounting the fixture to the wall.
start here
1422
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Note: Maximum wattage for 1422 fixture is 100 watts per bulb.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
1. Please refer to the hanging instruction sheet (I.S. 19) provided to continue installation
of this fixture. Then refer back to this sheet to install glass.
1. To install glass, insert threaded tube (2) with knurl nut and washer through the
center hole in the bottom of the glass globe (1) and hold in position- see Drawing 2.
2. Slip washer (3) onto exposed end of threaded tube (2).
3. Thread knurl nut (4) onto threaded tube (2) and hand-tighten only.
4. Slip cap (5) onto threaded tube (2).
5. Thread hex nut (6) onto threaded tube (2) and hand-tighten.
6. Thread finial (7) onto end of threaded tube (2) and hand-tighten.
7. Set globe (1) aside to be installed later.
1. Slip loop (11) along wire and thread onto top of fixture- see Drawings 1 and 2.
2. To remove the glass clips (8) by using a Philips screwdriver to remove screw (9) from
the inside top edge of the cage.
3. Tilt glass panels at an angle and insert them throught the panel opening on the side
of the cage. Place bottom of glass behind the tab in the bottom of the cage.
4. After all panels are inserted replace the glass clips that were removed earlier.
Drawing 1 - Fixture Assembly
Drawing 2 - Fixture Assembly
1
10
2
11
5
7
3 4
6
8
9
12.10.08
1. Fixture can now be lamped accordingly.
2. Install interior globe (1) using the small thumb screws (10) provided - see Drawing 2.
5
6
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com