Start here, I.s.19-80, Hanging instructions – Hinkley Lighting CIRRUS 3804BN User Manual

Page 2

1. Shut off electrical current before starting. If the fixture you are replacing is
turned on and off by a wall switch, simply turn the switch off. If not, remove
the appropriate fuse (or open the circut breakers) until the fixture is dead.

• DO NOT restore current - either by fuse, breaker or switch - until the new
fixture is completely wired and in place.

1. In the following order: take retainer ring (I), decorative plate (H) (if used) and
canopy (G) and slide them over the rods (R) attached previously.
2. Slip mounting plate with swivel (A) along wires and thread into top of rods (R).
3. Attach universal mounting strap (B) to the junction box (J) with screws (C).
4. Slip holes (E) in mounting plate with swivel (A) over screws (D) in universal mount-
ing strap (B).
5. Thread ball knobs (F) onto screws (D) to secure fixture to universal strap (B).
6. All necessary wiring can be done at this time. Please follow I.S. 18 for wiring
instructions.
7. Slip canopy (G) up along rods (R) and over mounting plate with swivel (A).
8. If installing optional decorative plate, slip decorative plate (H) up to canopy (G).
9. Slip retaining ring (L) up to canopy and thread onto coupler (K), located on the
mounting plate and swivel assembly, to secure parts.
10. Return to assembly instruction to complete assembly of this fixture.

start here

SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

Drawing 1 - Fixture Assembly

swivel

I.S.19-80

hanging instructions

I.S

. 19-80

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com