Hinkley Lighting ZELDA 3449PN - Manual

assembly instructions
item No. 3449
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
*** The construction of this fixture will be accomplished by first assembling the
main body of the fixture, installing the mounting bracket, making all necessary
wiring connections, mounting the fiture to the ceiling, and then installing the glass.
start here
3449
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
06.01.13
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, Ohio 44012 800-446-5539 www.hinkleylighting.com
Please refer to the hanging instruction sheet (I.S. 19) provided to hang this fixture. Then
refer back to this sheet to install the glass.
1. After fixture body is installed, slip glass (9) onto center stem (3) and hold in
position - see Drawing-1.
2. Slip rubber washer (10) and thread on ring nut (11) onto center stem (3) to secure
glass.
3. Thread thread decorative ball (12) onto center stem (3) and tighten.
4. Slip shade (13) over glass and set tabs inside shade onto top of glass. Center shade
on glass.
Drawing 1 - Fixture Assembly
1
2
7
5
3
4
6
8
9
10
13
shade
tab
11
12
1. To assmeble main body of fixture, first slip top column (T) along supply wire and
thread into top center column (B).
2. Next thread hex nut (4) onto end of center stem (3) approximately 3/8” - see
Drawing 1.
3. Thread the center stem (3) into coupler (2), located at the bottom of cluster
assembly (1), approximately 3/8”.
4. Tighten hex nut (4) against coupler (2) to sceure center stem (3).
5. Slip tube (5) over center stem (3) followed by cap (6) and hold in position.
6. Slip steel washer (7) followed by rubber washer (8) onto end of center stem (3).
Note: friction from rubber washer should hold parts in postion.
7. Fixture can now be installed. After installation return to these instructions for
glass and shade installation.
B
T